42- BOL CHANGER - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: 42- BOL CHANGER (/showthread.php?tid=10180)

---

42- BOL CHANGER - davidff - 07-31-2014

I am trying to get this challenging record changer to operate and the "bell drive" wheel and the other turntable drive wheels are shot. Does anyone know who rebuilds them or any suggestions on how I can get them operable? Thanks for reading.

---

RE: 42- BOL CHANGER - sam - 07-31-2014

try here
http://www.west-techservices.com/

---

RE: 42- BOL CHANGER - Ron Ramirez - 07-31-2014

West-Tech no longer rebuilds these changers.

Try Jim Koehler in Freeport, Long Island, NY. Listed on this site's Resources pages:
http://www.philcoradio.com/resourceb.htm#s

---

RE: 42- BOL CHANGER - davidff - 07-31-2014

Thanks for the feedback. I already emailed Jim and will be sending him the changer this fall. I wanted to see if I could get it going myself if there was a place to send the bell drive for a rebuild. If not, I will just wait for Jim. The 41 changer is so much easier to work with than this monster. I can do the tone arm rebuild myself, but this changer is way to complicated for me.

---