38-690 chassis and tuner rubber washers? - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Home Radios (https://philcoradio.com/phorum/forumdisplay.php?fid=6)
+--- Thread: 38-690 chassis and tuner rubber washers? (/showthread.php?tid=20049)

---

38-690 chassis and tuner rubber washers? - sdradioman - 05-30-2019

Was wondering if someone could tell me the correct chassis mounting washers along with the RF subchassis mounting washers for a 38-690? I see Renovated radios list them for 690/116, but dont know if that means 37/38-690...

---

RE: 38-690 chassis and tuner rubber washers? - morzh - 05-30-2019

If you meant these

http://www.renovatedradios.com/product.php?product=269

these are not for RF subchassis.


And these are specifically for 690

http://www.renovatedradios.com/product.php?product=278

---

RE: 38-690 chassis and tuner rubber washers? - sdradioman - 05-30-2019

What messed with me is they both say chassis support... so the 1st ones are what support the chassis in the cabinet, I’m assuming 4 of them, and the set of 3 are for the tuner sub-chassis that sets on the main chassis?

---

RE: 38-690 chassis and tuner rubber washers? - morzh - 05-30-2019

To support the subchassis you need three - one rear and two sides.

There was also (haven't found it) a small grommet that goes in the tuning cap itself for the rotor support. But it is not for the chassis itself and you might or might not need it.

---

RE: 38-690 chassis and tuner rubber washers? - Phlogiston - 05-31-2019

Trivia - the 2 side supports are slightly different from the one in the back.

---

RE: 38-690 chassis and tuner rubber washers? - morzh - 05-31-2019

Yes I think the back one has longer internal cylinder than the sides.

---