Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 42-360 3rd.IF can (32-3640))
#1

I am re-capping this 42-360. I found the Primary open on the 3rd. IF can.(32-3640) Red and white wires should be 14 ohms.
What can I replace this with? Also after opening up the can to replace the wires, there are no 100uuf caps  inside the can.The schematic shows  two of these in the can.
#2

Got two answers. One connect a rf choke from the red to white wires then a small mica from the white to green wires. Or find a 455kc if output can and replace it or just the open winding.
http://philcoradio.com/phorum/showthread.php?tid=15651
Start reading at post 15.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Hope that thread helps! Terry talked me through it.
#4

Radioengineer this is Gizmo
I have a Philco 42-360 and all the electronics are working. My problem is i need a dial string diagram? The good news is i live in Springfield,Il. not far from Pawnee.
Perhaps we could get together to our mutual benefit.




Users browsing this thread: 1 Guest(s)