12-31-2017, 09:06 AM
before i go into the expense of that and the waiting for the sig gen & the freq sensor (10$ unit you recommended) which isnt a problem, how to i confirm that is true?
i guess i couldl go back through my voltage readings to verify they are meeting the specs within the manual.
that tells me i am back to where i was when the set initially went to a no sound state.
i am back to where i was,,,
when i power with volume at about 80% i hear what seems to be only 20% volume.
after the tubes come on line, the volume ramps down to the point its nearly impossible to hear. but I then set the volume to 100% and it sounds like its putting out sound like 10%.
With these new caps installed, the symptoms are all lower audible levels than before.
when i intially powered up with the replacement caps on T10, i did hear some additional poping noises.
I looked into the patent of the IF's and apperently even in the write up the wording implied that it was not nessessary to provide values for individual components!, seems like it was secret squirril stuff.
I have two replacement IF's with a supplier name on the container called STAG. i am going to see if there are data sheets anywhere on line for Stag.
there is one youtube vid where a S53-a was the radio being worked and in this one single vid pertaining to silver mica caps, the guy discovered that in this set T10 was a totally different ferad rating CAP. He assumed 100pf and was running his slugs too far out and started over then discovered this. The manual says T10 & 11 are the same pn from T12. He discovered there may be an error in the manual,, and that T10 , the one closest to the antenna is actually different.
i guess i couldl go back through my voltage readings to verify they are meeting the specs within the manual.
that tells me i am back to where i was when the set initially went to a no sound state.
i am back to where i was,,,
when i power with volume at about 80% i hear what seems to be only 20% volume.
after the tubes come on line, the volume ramps down to the point its nearly impossible to hear. but I then set the volume to 100% and it sounds like its putting out sound like 10%.
With these new caps installed, the symptoms are all lower audible levels than before.
when i intially powered up with the replacement caps on T10, i did hear some additional poping noises.
I looked into the patent of the IF's and apperently even in the write up the wording implied that it was not nessessary to provide values for individual components!, seems like it was secret squirril stuff.
I have two replacement IF's with a supplier name on the container called STAG. i am going to see if there are data sheets anywhere on line for Stag.
there is one youtube vid where a S53-a was the radio being worked and in this one single vid pertaining to silver mica caps, the guy discovered that in this set T10 was a totally different ferad rating CAP. He assumed 100pf and was running his slugs too far out and started over then discovered this. The manual says T10 & 11 are the same pn from T12. He discovered there may be an error in the manual,, and that T10 , the one closest to the antenna is actually different.
