Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Speaker connector?
#1

Working on a Philco G1528 auto radio. Need a connector for the speaker leads. The socket on the cabinet is a round plate with 3 holes of approximately 1/8 inch dia for the plug pins.

Does any one know where I can get something to fit? Or what to use/make?

Thanks

Gary
#2

Have used pins from a Molex connector to make up odd connector. Can be had a RS and come in two sizes. They can be expanded with a little bit of prying with a small screwdriver.
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

I should have thought of the Molex connector pins. Have several in the junk box.

However I since tried an RCA plug and the pin is a perfect fit! Just had to grind off and remove the metat ring and the plastic and now have a nice pin to use.

Thanks for the suggestion. You might want to check out the RCA pin.

Gary




Users browsing this thread: 1 Guest(s)