Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Alignment (currently Philco Model 44 (121)
#1

I have a neat little book on Philco aligning, and it says to use a fibre hex nut. Looks like they don't make those anymore! What do you guys use so that you don't get electrocuted>? I'm thinking I need a signal generator...do I need an output meter also? Any assistance would be appreciated.
#2

For a non-conductive nut driver, I found an old VOM probe, clamped a 1/4" headed screw in a vise and heated it with a pocket lighter, then melted the head into the end of the hollow probe. it works great.

Ron F




Users browsing this thread: 1 Guest(s)