|
42-380 escutcheon related
08-15-2016, 09:54 PM
Screws or tabs???
When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
08-16-2016, 02:26 AM
(08-15-2016, 05:39 PM)Warren Wrote:(08-14-2016, 10:06 PM)spiderdrummer24 Wrote:(08-12-2016, 01:39 PM)klondike98 Wrote:Ok but how do you unscrew them and screw them in? They have no groove(08-11-2016, 09:51 PM)spiderdrummer24 Wrote: do you just hammer in the new ones after you drill the hole? Yeah they're drive screws.
08-16-2016, 11:59 AM
(08-16-2016, 02:26 AM)spiderdrummer24 Wrote:(08-15-2016, 05:39 PM)Warren Wrote:(08-14-2016, 10:06 PM)spiderdrummer24 Wrote:(08-12-2016, 01:39 PM)klondike98 Wrote:Ok but how do you unscrew them and screw them in? They have no groove(08-11-2016, 09:51 PM)spiderdrummer24 Wrote: do you just hammer in the new ones after you drill the hole? Sorry meant Sam's post with the pick. When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry 
08-16-2016, 12:07 PM
terry
I had good luck with a fada 80 door that used what looks like screws like these. but smaller brass ones used angled sharp pick. pulled straight up on sides little at a time then used pliers and twist out taped ever so gentle with plastic faced hammer luck maybe Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift mafiamen2
« Next Oldest | Next Newest »
Users browsing this thread: 1 Guest(s) |
actually you might be right about tapping them.in with a hammer. I have seen screws like that before. Does it have a head that looks like a round nail haad and are the "threads" different than it's screws? They kind of go up the screw instead of around aND around? If so then they need to be tapped in carefully.