07-12-2014, 05:24 PM
A while back I started on a 39-25 and posted some in the electronics section but got sidetracked into working on the cabinet. I wasn't sure if this one was going to clean up. Here is the as received photo:
Grungy dial cover:
Chassis and dial cover removed:
The corner got banged up with a loss of glue block and veneer:
The cabinet actually cleaned up pretty well with some Citristrip:
The dial cover also cleaned up with some scrubbing but that takes it down to the brass instead of the original gold/brass paint. Thanks to Bob Andersen's youtube video I knew what to do:
This was my second attempt at veneer repair and it seemed to come out reasonably well. The glue block fix was pretty straight forward:
There was a black water stain on the top of the cabinet...probably somebody's plant stand in the past but it cleared up with an oxalic acid treatment:
After toner and the first coat of clear its beginning to look much better:
I'll post a final photo when the chassis is finished and the final lacquer rub out is done.
Grungy dial cover:
Chassis and dial cover removed:
The corner got banged up with a loss of glue block and veneer:
The cabinet actually cleaned up pretty well with some Citristrip:
The dial cover also cleaned up with some scrubbing but that takes it down to the brass instead of the original gold/brass paint. Thanks to Bob Andersen's youtube video I knew what to do:
This was my second attempt at veneer repair and it seemed to come out reasonably well. The glue block fix was pretty straight forward:
There was a black water stain on the top of the cabinet...probably somebody's plant stand in the past but it cleared up with an oxalic acid treatment:
After toner and the first coat of clear its beginning to look much better:
I'll post a final photo when the chassis is finished and the final lacquer rub out is done.