Picture of Part
According to schematic the center contact on this pot should go to ground. But it never did. Did philco goof? this could never work as tone control it Part # 67 Tone control ( Audio base)
Thanks
Skip...
Measure the wiper to gnd with an ohm meter. It may have an internal gnd connection. If not gnd it.
Terry
Yes, it is usually connected without being soldered.
Yup center is grounded.. Thanks never seen a pot that the center was grounded internal.
Thanks
Skip...
Sometimes it is a ring riveted to the middle pin (or soldered) that goes around the shaft so when mounted it provides the grounding.