05-28-2015, 10:10 PM
I was missing one of those clips that hold the coils down and figured I'd try and make something.
Then one of those springy paper clips came to mind.
Its a bit thicker but maybe it will just work.
Cut it down a bit, spread it out a tad and filed the the tips to take off any sharp points
Installed and holding rather well (middle coil in pic). There may be a better smaller paper clip available but this is working.
Anyway, others may have done same I'm just throwing this out there
Then one of those springy paper clips came to mind.
Its a bit thicker but maybe it will just work.
Cut it down a bit, spread it out a tad and filed the the tips to take off any sharp points
Installed and holding rather well (middle coil in pic). There may be a better smaller paper clip available but this is working.
Anyway, others may have done same I'm just throwing this out there