kl
yes arblll should work
sam
(06-26-2015, 11:03 AM)sam Wrote: [ -> ]kl
yes arblll should work
sam
Thanks Sam! I had both the cathedral and the floor model and sold the cathedral on ebay (mistake). But I would like to have the console working.
(06-26-2015, 02:01 PM)klondike98 Wrote: [ -> ]Welcome to the Phorum!!
Thanks Bob. I have corresponded with Ron for years but never signed on the Phorum. Several of the 37 philcos in the gallery are mine.
Not sure if it will. The 37-33 requires two bias voltages -3 and -9v. It's simple enough to wire up a battery or two for these voltages. Then all you need is +135v, 90v, and 2v for the filaments. Be sure to throttle back the filament voltage if you have been using the p/s on a set with 01A's.
Terry
ps After looking at the link it should work fine!!!
(06-29-2015, 06:24 AM)Radioroslyn Wrote: [ -> ]Not sure if it will. The 37-33 requires two bias voltages -3 and -9v. It's simple enough to wire up a battery or two for these voltages. Then all you need is +135v, 90v, and 2v for the filaments. Be sure to throttle back the filament voltage if you have been using the p/s on a set with 01A's.
Terry
ps After looking at the link it should work fine!!!
Thanks! I had already ordered it. I know I could rig it but I am getting lazy in my old age.
It's a good playing set . I've got the table model picked it up 30yrs ago. Was in ruff shape and was missing the spkr. Used an 8"pm spkr w/a p/p output transformer.
Terry
(06-29-2015, 02:44 PM)Radioroslyn Wrote: [ -> ]It's a good playing set . I've got the table model picked it up 30yrs ago. Was in ruff shape and was missing the spkr. Used an 8"pm spkr w/a p/p output transformer.
Terry
Terry,
I had both the cathedral and floor models of the 37-33 and decided to part with the cathedral as the cabinet is the same as several other models I have on display. BUT it sold for less than $30 on ebay and it was in excellent condition.
KLB