02-19-2017, 07:25 PM
02-19-2017, 07:25 PM
02-20-2017, 02:02 PM
02-20-2017, 07:52 PM
Neat set, a brown version of this is featured in a late 3 Stooges, with Shemp. They are income tax preparers, the red lite when on is cool. Good luck.
Paul
Paul
02-26-2017, 09:09 PM
02-27-2017, 11:23 PM
Ok, Since no answers.. I put together 2 .1 600 Volt caps in series to make a .05 at 1200 Volts and put in ..
Finished wiring up the E-Caps and tomorrow will power it up..
Skip..
Finished wiring up the E-Caps and tomorrow will power it up..
Skip..
02-28-2017, 08:11 AM
200V is more than enough.
02-28-2017, 12:34 PM
You might want a high voltage cap in that location. It connects between the chassis and AC line.
Depending on which way the line cord is plugged in, its either neutral or hot connected to the chassis if the cap shorts.
Depending on which way the line cord is plugged in, its either neutral or hot connected to the chassis if the cap shorts.
02-28-2017, 07:30 PM
Ok, Thanks all.. Completed the Caps and resistors replacement. Plugged in and brought up slowly. At 117 Volts draws .25 amps.. Radio plays and picks up many stations.. On to alignment as dial is off a little..
Skip...
Skip...
03-01-2017, 06:58 PM
Wow,,,there must be 3 ,,,R-6's,,,there are 2 together,,,470,000 ohms,,,thee other may ?? be a mistake , (Label) ,better Check you parts list closely,,,CHEERS
03-01-2017, 07:18 PM
on Zenith 6D015---R-3 is 1000 ohms----which is in the SAME location off the tube 12SA7GT of YOURS ( R-6,,220 ohms resistor),,which READS 1K,, CHEERS again