I always install a fuse in my old radio restores but the Philco 610 does not seem to have any convenient place to mount one. The area where the line cord goes into the block is pretty crowded. I was wondering what other people have done?
Hi Bob,
You can use a fuse w/pigtails and just solder it in between the block and transformer primary. I've seen some 3AG style fuses w/ wires attached. A bit of shrink tubing and your good.
Have seen some that use automotive inline holders but I think it looks cheesey. Don't know if the insulation is up to the task either.
I have used those automotive inline fuses on a few other (newer) radios and they worked but kind of ugly. I have seen a few videos where they used fuses with the pigtails and I was leaning toward that.
If your not using your DX-100 pull the plug off of it and put in a couple of quarter amp fuses in it
I often use an inline fuse holder for an AGC type fuse and just tuck it up inside the chassis. I much prefer the accessibility of a panel mount though...but if there's no room, there's no room.
Rob
That would be my preference as well however in this 610 there just is no good spot in the area of the AC line cord. I am going to try to use a fuse with the pigtails on it and some shrink wrap to make sure it can not get shorted.