Model 70 Closeup picture of EC's and Speaker plug - Printable Version
+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Model 70 Closeup picture of EC's and Speaker plug (/showthread.php?tid=21836)
+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Model 70 Closeup picture of EC's and Speaker plug (/showthread.php?tid=21836)
Pages:
1
2
RE: Model 70 Closeup picture of EC's and Speaker plug - Glenn Roberts - 11-25-2020
I'm totally over it.. On to the next project..
RE: Model 70 Closeup picture of EC's and Speaker plug - radio1 - 11-26-2020
FYI, found that the wireround mountings on the 70 is slotted open at the rear, just loosen and the wirewound resistor will slide out the back side to examine. I replaced the old deteriorating fiber washers at each end and cleaned it all up, replacing with new washers. My part was visible on the sticker - part 5125.
RE: Model 70 Closeup picture of EC's and Speaker plug - Glenn Roberts - 11-27-2020
That is true. I had the same issue with this one and loosened them and slide the long bolt out to replace the washers. it was easier because I had loosened up the 5 terminal which was connected to a ground strap.