Model 60, reattaching dial, where to index back to? - Printable Version
+- The PHILCO Phorum (
https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (
https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (
https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Model 60, reattaching dial, where to index back to? (
/showthread.php?tid=1425)
Model 60, reattaching dial, where to index back to? -
MinnesotaHam - 10-16-2008
I removed the dial to ultrasonic clean the tuning cap and refurbish the vernier drive.
Does Philco recommend where to index the dial back to the pointer upon replacement?
It's not my first alignment or removed dial, just curious if Philco had an index location specified.
Re: Model 60, reattaching dial, where to index back to? -
Ron Ramirez - 10-17-2008
Hi
There should be an index line below 55 on the dial. That would be where you set it, with the plates of the tuning condenser fully meshed.
Re: Model 60, reattaching dial, where to index back to? -
MinnesotaHam - 10-17-2008
Thank you.