Philco signal tracer model 7030 - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Various and Sundry Categories (https://philcoradio.com/phorum/forumdisplay.php?fid=37)
+--- Forum: Test Equipment (https://philcoradio.com/phorum/forumdisplay.php?fid=31)
+--- Thread: Philco signal tracer model 7030 (/showthread.php?tid=15461)

---

Philco signal tracer model 7030 - Hank G - 09-29-2016

I have picked up a 7030 in very good exterior condition, makes a nice display piece. I am wondering if restored it would have better performance than a common Heath or Eico unit.
Thanks
Hank

---

RE: Philco signal tracer model 7030 - KCMike - 10-01-2016

I have one that I replaced the caps in and had to resolder the cable where it went into the probe. There is a tube in the probe.
I have not used it for troubleshooting yet but here is an instruction manual in case you don't have one.
http://www.myvintagetv.com/Apple%20PDF%20files/Philco%207030%20Tester.pdf
Don't know if its better than Heath or Eico. Maybe someone can comment on that.

---

RE: Philco signal tracer model 7030 - Hank G - 10-05-2016

(10-01-2016, 08:39 PM)KCMike Wrote:  I have one that I replaced the caps in and had to resolder the cable where it went into the probe. There is a tube in the probe.
I have not used it for troubleshooting yet but here is an instruction manual in case you don't have one.
http://www.myvintagetv.com/Apple%20PDF%20files/Philco%207030%20Tester.pdf
Don't know if its better than Heath or Eico. Maybe someone can comment on that.

Thanks, I downloaded the manual, sounds interesting.  I think I will go throuth it, and try it out.  I did slide the the probe apart, some of the terminal clearances are very close and could use insulation.
Hank

---