The PHILCO Phorum
Getting some of the ugly gone - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Cabinet Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=9)
+--- Thread: Getting some of the ugly gone (/showthread.php?tid=17457)


Getting some of the ugly gone - Radioroslyn - 10-31-2017

Over the last several days I've been working on a couple of bad looking Philcos. One an late '36 84B and the other is an 80B. Both needed the chassis serviced which was done also.

I was a bit surprised that Philco went to trouble to add some nice details to the cabinet on the 80B (bear in mind this was a $15 set in late 1932. Two tone finish, routed base trim, routed speaker panel, and routed front panel edge. The model 81 has the same details too. This helps show the family resemblance to the lager model 91 and other Clyde Sutter designed cabinets. The 84B dropped a lot of the routing and just had the edge and opening cut with bandsaw leaving just a flat edge.

RE: Getting some of the ugly gone - Ron Ramirez - 10-31-2017

Say, Terry, great job on both! Icon_thumbup

RE: Getting some of the ugly gone - klondike98 - 11-01-2017

Looking good Terry!
Icon_thumbup Icon_thumbup Icon_thumbup

RE: Getting some of the ugly gone - PhilcoPhan1936 - 11-01-2017

Very nice! Icon_thumbup

RE: Getting some of the ugly gone - Arran - 11-05-2017

Terry;
  The grilles in those model 84s are probably routed to, if not then then used some 1930s version of a RotoZip to cut them. You can tell by the rounded out corners that they used a rotary tool and a jig to cut them, but by then the molded edges around speaker grilles cutouts that sets like the 80 and 81 had were going out of fashion in favor of ones with a 90 degree edge.
Regards
Arran

RE: Getting some of the ugly gone - falcon123 - 04-03-2018

probably done on a pantograph using a high speed single lipped cutter

RE: Getting some of the ugly gone - PhilcoJohn - 04-03-2018

As Freddy Prince used to say....  Looking Good!  Icon_thumbup

RE: Getting some of the ugly gone - OldRestorer - 04-03-2018

Wow,
Super nice looking job Terry... I have a chairside here you can do Icon_lol

Icon_smile

RE: Getting some of the ugly gone - Radioroslyn - 04-03-2018

Flattery will get you nowhere!!!!
Get busy!!!!  [Image: http://philcoradio.com/phorum/images/smilies/icon_lol.gif].
Just think of ALL the swell pics you can post as your redoing it! All the Phorum members going ew and ah! And and the great big attaboy you'll get from me!!

RE: Getting some of the ugly gone - murf - 04-03-2018

Very nice restoration Terry!
murf