112 schematic discrepancy? - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: 112 schematic discrepancy? (/showthread.php?tid=18776)

---

112 schematic discrepancy? - Brad Winder - 08-04-2018

I am rebuilding the filter capacitor on my 112 chassis...and I have run into a problem with the schematic and diagrams not agreeing. I have compared the schematics in the Philco 28-36 book, with the Service Bulletin, with Raf Bintliff's book. The diagram of the internals of the capacitor block don't jive with the schematic. Particulars is the capacitors between lug 8-9, 9-3, and 10-3. The diagram says a 0.15uF goes between 8-9, a 2uF goes between 9-3, and a 2uF goes between 10-3. But the schematic says that a capacitor goes between lug 8-3, lug 10-9, and 9-3.

Does anyone have knowledge of which is right?

---

RE: 112 schematic discrepancy? - Ron Ramirez - 08-04-2018

Well, I'll be darned...I never noticed that before.

There is an error on the schematic. I've straightened it out below:

   

I've corrected the 112 (Early) schematic in the Philco Schematics section of the Phorum. I've also corrected the 111 schematic which had the same error.

---

RE: 112 schematic discrepancy? - Brad Winder - 08-04-2018

Thanks Ron!! Now I'll be able to finish the block rebuild tonight!

I'll add a note to the schematics in my books as well.

---