SUPERIOR INSTRUMENTS CO. C.R. BRIDGE AND SIGNAL TESTER -
vecher - 12-02-2018
Ok started to work on this.. A Model 76..I have a copy of manual and schematic.. However some of parts do not follow manual as to value.. EX: one resistor said 250K but I have a 42K in that place.. Also a lot of different hookup not following schematic..
Did anyone work on this model? I am not sure if to change everything according to manual and schematic or to leave as is and just replace out of Tolerance parts???
Thoughts..
Skip
RE: SUPERIOR INSTRUMENTS CO. C.R. BRIDGE AND SIGNAL TESTER -
vecher - 12-02-2018
Ok, Changed the Filter cap.. powered up and seems to work.. measured a resistor and a cap.. pretty close on dial..
eye tube nice and bright a little sensitive on adjustment
did not check the tracer part yet..
But now i will replace all of the other caps that need it.. Then try again..
One question Where can I get the banana type plugs that go to front panel so i can make up some test leads..
Skip
RE: SUPERIOR INSTRUMENTS CO. C.R. BRIDGE AND SIGNAL TESTER -
Greggshere - 12-03-2018
I bought banana plugs for a meter box I built from Amazon. They are duals but you can take them apart and make singles. Below is the description:
Wiwaplex 10Pcs Gold plated Insulated Terminal Binding Post Power Amplifier Dual 2-way Banana Plug Jack
RE: SUPERIOR INSTRUMENTS CO. C.R. BRIDGE AND SIGNAL TESTER -
vecher - 12-29-2018
Ok, All caps replaced.. Seems to be working as I can read Resistance and Capacitance.. The Signal Tracer seems to work also..
Not sure about RF side though.. I do not have the RF probe.. I tried to make one from the instructions but doesn't seem to work Right..
Get no deflection on tube or hear nothing in speakers..
Skip