The PHILCO Phorum
Philco 49-504 - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Philco 49-504 (/showthread.php?tid=19441)


Philco 49-504 - Marko - 01-01-2019

I picked up a Philco 49-504 radio in hopes of restoring. The radio has had caps and resistor changes some 40 years ago and wire changes as well. I downloaded the riders schematic and saw pictures of other 49-504 chassis restores and i see parts not in my set? The biggest thing i see is the 3 section filter cap mine is a 2 section and other parts not under my chassis? Any help would be great...

RE: Philco 49-504 - Radioroslyn - 01-01-2019

https://www.americanradiohistory.com/Rider-Manual.htm
Click on 1949 and then PQR go to pg 164
Much better scan than NA.
Original circuit has three filter caps as does yours.

RE: Philco 49-504 - Marko - 01-02-2019

Thank you that should help out. Icon_angel

RE: Philco 49-504 - Marko - 01-08-2019

Well I am stuck again I downloaded the schematic from Nostalgia Air and on the alignment page figure 7 it shows the dial cord layout but does not mention whether  the tuning condenser is closed or open when putting a new cord on. Also wonder why Philco used 2 dial strings on this because most all other table radios use one? The diagram is difficult to see exact layouts, I've tried everything????? Any help?

RE: Philco 49-504 - sam - 01-08-2019

marko         other thread deleted
please read phorum rules

http://philcoradio.com/phorum/showthread.php?tid=4586
II. Multiple threads on the same subject not allowed.

When you start a thread, please keep the discussion within the same thread.




sam

RE: Philco 49-504 - KCMike - 01-08-2019

Hello. According to Sams dial string dia. The tuning gang should be fully closed.

RE: Philco 49-504 - Marko - 01-08-2019

Hi, do you have a copy of the sams dial string diagram? The diagram I have doesn’t show the springs or a clear view of the diagrams?

RE: Philco 49-504 - klondike98 - 01-08-2019

Here's the Sams image:
[Image: https://www.dropbox.com/s/bst0wvh194ktorf/philco49-504_samsDial.png?raw=1]

and a better image of the Riders schematic:

[Image: https://www.dropbox.com/s/4y8fibifnaiojfq/philco49-504_RidersDial.png?raw=1]

RE: Philco 49-504 - KCMike - 01-08-2019

Thanks Bob for helping. I couldn't figure out how to convert that picture in the file to send Marko

RE: Philco 49-504 - klondike98 - 01-08-2019

Icon_thumbup

RE: Philco 49-504 - Marko - 01-08-2019

That’s great thank you so much now I can restring.??