3D Printed Parts... - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: 3D Printed Parts... (/showthread.php?tid=23963)

---

3D Printed Parts... - promocom - 12-15-2022

I was missing the original electro Caps and the clamp for the 630B tombstone I have, and thought it would be a good job for my 3D printer. Also I made some tubes the same size as the tubular caps in the radio and printed some labels for them too.

---

RE: 3D Printed Parts... - klondike98 - 12-15-2022

Nice work!  I think 3D printing will become a real positive source for replacement parts not otherwise available.  I used a service (you send them the design and they send you the part) to create a bezel to replace a warped tenite bezel for a Stromberg-Carlson 320-T
Its pretty basic but seems to be OK.
[Image: https://www.dropbox.com/s/rj94ztrcghjasnd/stromberg-carlson320T_34.jpg?raw=1]

---

RE: 3D Printed Parts... - radiorich - 12-15-2022

hello promocom,
Nice job myself I use fusion 360 alot !
Bob I agree with you about future parts I have made a few items .

Sincerely Richard

---