Philco 77 Resistor - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Philco 77 Resistor (/showthread.php?tid=24948)

---

Philco 77 Resistor - gbreisdorf - 03-17-2024

Greetings everyone!

I recently was given a Philco Model 77.  Cabinet is in great shape, almost looks new.  I am going to replace all of the capacitors and that shouldn't be too tough once I get past the tar.  My question is in regard to one of the wire wound tubular resistors.  The shorter one is a two-stage affair and the 800 ohm winding is open.  Looks like someone was into it before me and about half of the winding is missing, so even if I could re-connect, it would probably be the wrong value.  I was thinking about attaching a power resistor between the lugs and was wondering if 5 Watts would be sufficient, or if I should go higher?  The schematic makes reference to all resistors being 1 Watt, with the exception of the two wire wound jobs.  

I was also thinking about rewinding it, but not sure what type of wire I should use or where I may obtain it. 

Any advice would be appreciated.  

Thank you and regards,

George B. Reisdorf

---

RE: Philco 77 Resistor - mancave - 03-17-2024

There is a thread on this from last year containing answers to your question about resistor wattage as well as other advice. You may find it useful: https://philcoradio.com/phorum/showthread.php?tid=22361&highlight=Model+77

---

RE: Philco 77 Resistor - gbreisdorf - 03-17-2024

Thank you mancave! Good information.

gbr

---