The PHILCO Phorum
48-230 - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Cabinet Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=9)
+--- Thread: 48-230 (/showthread.php?tid=25025)



48-230 - SRv2 - 05-15-2024

Does anyone have an easy or simple method of removing the compression latches shown in the pictures here? When I have come across them I have had to mangle them off and replace them. These are pushed down on Bakelite posts so I am concerned about handling too roughly. Appreciate any tips. George


RE: 48-230 - radiorich - 05-15-2024

Hello George,
Well I have that same issue with my set when I get around to restoring and I am not going to even try removing them because fear of breaking the plastic posts off .

Sincerely Richard


RE: 48-230 - SRv2 - 05-15-2024

Thanks Richard, I came to the same conclusion.  I gently tried one of them and gave up.  I wanted to clean that waffle grill separately due to a lot of grime in each tiny square.  I ended up washing and q-tip cleaning without removing it, best I could.


RE: 48-230 - RodB - 05-15-2024

Hi guys, I had the same issue with the bezel on my 41-221. I used a jewelers screwdriver and a small flat blade screwdriver to get under the clip next to the center. Work one side then the other. It will slowly get looser. I removed all six this way. The main thing is to use a short screwdriver with the thinnest blade.

For the round clips I use a spring hook to hook the center teeth at the post and pull up at the center, working one side then the other.


RE: 48-230 - SRv2 - 05-15-2024

Hi Rod, that’s great feedback. I’ll try that. I had success similar to that on a D-655 Sportster. That was a metal shaft. I’m nervous about breaking these Bakelite shafts on the 48-230.


RE: 48-230 - radiorich - 05-16-2024

hello George,
Yes , my set if what they call the flying wedge and I too need to clean the grille .
Sincerely Richard