The PHILCO Phorum
Stuck Knob on 610B - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Cabinet Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=9)
+--- Thread: Stuck Knob on 610B (/showthread.php?tid=5986)



Stuck Knob on 610B - Perry - 02-14-2013

I have recently acquired a Philco 610B. One of the knobs refuses to come off. It is the center knob on the tunning control. The outter knob seems to move along the shaft a little bit, but the center knob is stuck fast (and, of course, it must come off first).

Natually, I would like to preserve the orginial knobs if at all possible. Do you have ideas on removing stuck knobs without damaging them?

Thank you,
Perry


RE: Stuck Knob on 610B - Ron Ramirez - 02-14-2013

Hi Perry

I moved this thread to Philco Cabinet Restoration as it seemed to be a more appropriate home for it.

Over the years, the most common "cure" I have read about for this problem is to put a piece of heavy string behind the stuck knob, wrap once around the shaft if at all possible, and then pull as hard as you can with both hands - one on either side of the knob, pulling on both ends of the string. Be aware that the knob may very well end up flying across the room.


RE: Stuck Knob on 610B - Arran - 02-15-2013

It also shouldn't hurt anything if you squirted some WD behind the front knob, very likely that the spring got stuck to the shaft, I had a knob stick to a splined steel control shaft once and that did the trick.
Regards
Arran


RE: Stuck Knob on 610B - Perry - 02-17-2013

Thanks for your suggestions. Because the inner and outer knobs are "nested", I could not get a string behind only the center knob. But, using a strong nylon twine wrapped on the shaft behind the outer knob and a steady pull, both knobs came off (undamaged).

I did not need penetrating oil this time, but I will keep it in mind for even more stubborn cases.

Thanks agin,
Perry