Philco 45 Tone Control Question - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Philco 45 Tone Control Question (/showthread.php?tid=729)

---

Philco 45 Tone Control Question - Guest - 08-12-2007

I've pretty much finished electronic restoration on 45 chassis. I took apart the bakelite block tone control module. Unfortunately, my RIDER schematic does not give me the values of the three caps inside the block. Can anyone tell me the values and what order they're wired in?
Thanks,
Britt
Chesapeake, VA

---

- Terry Judkins - 08-12-2007

The values are 0.01Uf, 0.02uF and 0.001uf.
The .001 is directly across to rotor common (ground) and is not switched. The .01 is connected to the center contact and the .02 is connected to the third contact. The first position is off and has no capacitor.
[Image: http://home.comcast.net/~suptjud/Philco45ToneControl.JPG]

---

- Guest - 08-13-2007

Terry...

I'm electronically challenged, but you made it very clear on how to wire the caps in....

THANKS,

Britt Abbott

---