Restoration/code changes - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Electronic Restoration (https://philcoradio.com/phorum/forumdisplay.php?fid=8)
+--- Thread: Restoration/code changes (/showthread.php?tid=850)

---

Restoration/code changes - TonyJSenior - 11-23-2007

Started recapping the chassis of a 38-7 table model and noticed a few differences between the console chassis and this one. I have to believe that they are production changes as the console has a resistor/clamp/thermal compensator mentioned in a run change while the table chassis does not. A few of the caps for the tone control were also the same as the print and not the values mentioned in one of the production run changes. Question I have is, typically when you recap/restore a chassis, if the chassis is an earlier run, do you also go through the run changes and change whatever is noted to bring it to the 'latest' production run?

---

- Ron Ramirez - 11-24-2007

It isn't necessary to bring an earlier production run up to specs of a later production run, unless you want to do so.

---