Philco 37-650 and 70 chassis washers - Printable Version

+- The PHILCO Phorum (https://philcoradio.com/phorum)
+-- Forum: Philco Radio Discussions (https://philcoradio.com/phorum/forumdisplay.php?fid=5)
+--- Forum: Philco Home Radios (https://philcoradio.com/phorum/forumdisplay.php?fid=6)
+--- Thread: Philco 37-650 and 70 chassis washers (/showthread.php?tid=16882)

---

Philco 37-650 and 70 chassis washers - Oldresistor47 - 06-25-2017

Can anyone recommend a vendor for the chassis washers of these two Philcos models, whom will not charge $4.00 a washer.

---

RE: Philco 37-650 and 70 chassis washers - morzh - 06-25-2017

Yep. Lowes or Home Depot. You could buy their grommets and trim them. If this is what you want to do.

---

RE: Philco 37-650 and 70 chassis washers - Oldresistor47 - 08-13-2017

Trying to finish this 37-650 and after several weeks of not working on it, I am not receiving any stations lower than 710 AM. Tried to start alignment and found AC signal just above 200 volts A/C. Procedure indicates meter should be in the 30 volt range. I have the positive on the plate of one of the audio amp tubes and negative on cathode. Any suggestions as to could be the problem. I don't get ay meter swing when adjusting comparators neither. Thanks

---

RE: Philco 37-650 and 70 chassis washers - morzh - 08-13-2017

I am not sure how you could get 200V AC across the output tuve, but myself, I always clip my meter to the output xfmr secondary (or speaker's voice coil) and measure volts.

---