1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Test Equipment
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Eico 950A Resis-Cap Comarator Bridge
Eric
Senior Member
****
Posts: 451
Threads: 85
Joined: Nov 2011
City: Cumming, GA
#1

08-19-2014, 11:23 AM
Got this Eico 950A for nothing so I thought I would restore it. What I found was this in my research. There was some changes made after sn 7500, mine is 12,309 primarliy the addition of a 4mfd cap in addition to the 8mfd which the schematic shows but not polarity.
Does anyone have info on this?
The 8mfd has the + side to chassis is this right?
Some of the wiring has been changed so I'm not sure what is correct? All I've run in to is for the 950 and 950B.

Any help would would be appreciated
Find
tab10672
Senior Member
****
Posts: 411
Threads: 42
Joined: Sep 2008
City: Ironton Ohio
#2

08-19-2014, 04:13 PM
I do know that if you replace the bridge caps they all have to be precise (I think my Heath were 2, .2, .02) because those are the caps used to calculate unknown capacitance.
Find
« Next Oldest | Next Newest »




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently 1607 online users. [Complete List]
» 1 Member(s) | 1606 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Test Equipment