Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

PLASTIC FEET FOR 1982 BALLANTINE MODEL 1032A OSCILLOSCOPE
#1

Say, does anyone know where to buy plastic feet for an oscilloscope? My unit only has two left, and I'd like to replace those, or buy a new matching set of comparable "feet".
#2

are the plastic or rubber  and do you have a pic  for use to match ?
sam
#3

Radio Daze has several rubber feet.  http://www.radiodaze.com/rubber-feet/
#4

If you have a good hardware store locally I'd try there first.... often they have a good assortment of things like that.  Next place to look would be on-line like the link above to Radio Daze or even scouring eBay for some.  I've found McMaster-Carr to have a great assortment of stuff like that:

http://www.mcmaster.com/#rubber-feet/=v6dj3p

http://www.ebay.com/sch/i.html?_from=R40...t&_sacat=0

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM
Looking for verification of correct schematic.
I think you have the correct take on your set. Ron's annotated early schematics that note the below B22000 serial numbe...klondike98 — 12:04 AM

[-]
Who's Online
There are currently no members online.

>