Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

I'm batting 1000
#16

(09-21-2015, 11:17 PM)Eric Adams Wrote:  I'm at the point where everything I touch turns to s**t! Icon_confused

I feel your pain. I really do. This is how I felt after my attempts at getting my Philco 604 up and running failed.

It is now on a "punishment shelf". Icon_wink

And then I tackled a 37-670 and it turned out fine.

Go figure.

These things happen. You will figure it out eventually. I know I will figure out that 604 eventually, also. Icon_thumbup

--
Ron Ramirez
Ferdinand IN
#17

Eric,


You might be chasing two problems here.
First, you might have an intermittent connection in your oscillator circuit.  Initially, you could only receive 720, but after seemingly no changes, it was 'locked' to your sstran at 1500.
Second, something is causing the oscillator to not vary its frequency with dial changes. 


Things I would check.
Does your loop antenna have continuity?  Is it correctly hooked up?
Same for the oscillator coil.  Continuity on the different turns?  Connected up right?
Is there anything connected in the oscillator circuit that shouldn't be there?  Solder blob shorting something, or mistake from a prior rework?


Good luck,
Jon




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently no members online.

>