Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Sears silvertone question
#16

Hello I do have a schematic. Don't remember where I got it from. I'll have to dig it out of the file and get back to you.
Do you have the same one with the wire recorder?
#17

I have the same model as described at https://www.radiomuseum.org/r/sears_roeb...01831.html Silvertone 8125 Ch= 101.831-1 Type 47 It's a beauty and complete except for the turntable. I've been searching everywhere to find schematics. Alignment details would also be great.
#18

Until I can get the schematic uploaded to send, and be advised it's not the greatest in regards to clarity,
here is a detailed restoration of one of these consoles in case you haven't seen this.
https://antiqueradios.com/forums/viewtop...r+tone+101
#19

Here is schematic I have and info on alignment. Sorry some pics are sideways.
https://i.imgur.com/e67fLoM.jpg
https://imgur.com/cfbIj7J
https://i.imgur.com/G2AHGwe.jpg
https://i.imgur.com/qwGLjnJ.jpg
https://i.imgur.com/0izQtuL.jpg
#20

Thanks for the files and your link to the restoration discussions of this Silvertone.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 2985 online users. [Complete List]
» 1 Member(s) | 2984 Guest(s)
Avatar

>