Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco model 20 chassis
#1

hi all,are there any other cabinets this chassis will fit in?
can't find a good used one reasonably,don't have the money for a new repro and the cab i have is not repairable.
thanks,phil
#2

You're pretty much limited to Model 20 cathedral or console, Model 21 cathedral or console, or Model 46 cathedral or console.

--
Ron Ramirez
Ferdinand IN
#3

Are you sure that it isn't repairable? I've see some pretty awful looking cabinets repaired, I've fixed a few myself. Dick Oliver, the fellow who makes the reproduction cabinets, also makes cabinet parts to repair original cabinets. I don't know if you can do that with a Philco 20 but it's worth looking into. If push comes to shove you should be able to find an empty cabinet or another 20 with a butchered chassis, it just takes time but they are out there.
Happy Christmas
Happy New Year
#4

hi guys,thanks for the responses. i don't have the cab here yet but from the pics the cab is toast. i got what i considered a good deal,the 20 and a 84b,both for $35 complete!.i'll see what i can do but both looked beyond my skill level to repair and money is a big issue now,as it is for most folks.
phil




Users browsing this thread:
[-]
Recent Posts
My Philco 37-116 Restore
Hello MrFixr55, Thank you for taking the time to explain. I measured 50 volts where you say. Today the 370 volts at ...dconant — 12:51 PM
462ron
Oh that sucks. It’s something easily overlooked. Hopefully it’s nothing more than a resistor! Ron462ron — 08:08 AM
Philco 46-480 Electronic Restoration
Just confirmed that you are correct. It’s the function generator. I connected the signal output probe to one of the inpu...jrblasde — 07:52 AM
Philco 46-480 Electronic Restoration
Ouch, you may be right. Yes, it is solid state. It’s the signal output of my oscilloscope. May be time to crack that ...jrblasde — 07:27 AM
462ron
If you didn’t put a DC blocking cap between the signal generator probe and the plate of the 1st IF it’s possible you ble...462ron — 07:07 AM
My Philco 37-116 Restore
Hi DConnant, The reason why C127 is isolated from ground is because sets of this vintage did not have the center tap...MrFixr55 — 01:07 AM
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM

[-]
Who's Online
There are currently no members online.

>