Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Best Bakelite era RCA 45 Player?
#1

Ok, here is a little quiz for everyone. What is the best bakelite, tabletop 45 player that RCA sold? So far my restored 45-EY-3 is the best 3 tube unit I've had so far. But, I also know that they sold a 4 tube unit (actually had one, but gave up on it and sold it), and that they sold little radio-phono combinations as well. I realize the best 45 players were probably the hi-fi units produced in wooden cabinets later on, but for now I'd like to see what ones of the bakelite era you guys like best. Gives me something to ponder over while I'm basically living at work over this 9 day stretch.

No matter where you go, there you are.
#2

The 9Y7 is a wooden cabinet radio/phono from 1949. It has a push pull amp and is probably the best sounding of the early tabletop models. As far as the Bakelite 45 players go, I don’t notice much difference between a 9-EY-3, 45-EY-2 or 45-EY-3. They are all pretty similar three tube amps with no tone controls. The nicer sounding units usually include a radio.
#3

I have a 9Y7, but it is in need of a good bit of help. The major issue is that it is missing the inner cover panel that goes over the chassis. Right now you can open the lid and look right down into the dirty chassis with its broken dial cord. Icon_sad Took me over a year to finally find what model it was as well as the tag is halfway worn off!

No matter where you go, there you are.
#4

I have one too.  Mine still needs work but it’s complete.  I’m looking forward to getting it working but I have a few projects ahead of it.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently no members online.

>