Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco chassis 44 Newbbie help,
#1

New to this site, 1st post. 
I am restoring a philco standup radio chassis 44 looks like tuner is am and short wave.
There are 3 rubber tires in the tuner section, the one behind the dial plate and 2 more used in tuning and fine tuning. I got 2 of them but I need the 3rd(its the inner most one farthest from the dial plate) it is totally missing so I cant get it rebuilt.

Ayone have any thoughts or help. Thanks much appricated
Rich
#2

Hi Rich - welcome to the Phorum!

Have you seen this tech section article on rebuilding the dial drive for the 44 among others?
http://philcoradio.com/phorum/showthread.php?tid=14970

It should give you the info on the replacement part you need.
#3

thanks this is a big help and exactly what I need
#4

Welcome to the PHorum!
Icon_wave




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 3216 online users. [Complete List]
» 1 Member(s) | 3215 Guest(s)
Avatar

>