Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco radio grill
#1

Hello, I'm new on here and I have a question I hope someone can answer for me. I just picked up a Philco 49-506 wood cabinet radio that is in really good shape. The only thing is the plastic grill is a little rough.i have tried cleaning it and it still has stains and some deep scratches. Is there anyone out there that would have a nice grill for sale? Or is there a way of reconditioning one? Any info is greatly appreciated
#2

Hi;
  I think that the grilles in those are made out of polystyrene plastic, so a good bath in warm water and a little laundry soap should help, you will have to remove the grille from the cabinet naturally. It won't remove the scratches of course but it should make them less noticeable, unlike Bakelite polystyrene won't go dull from standard cleaning products. The only way to remove scratches in plastic is by wet sanding with extremely fine sandpaper, in a succession of steps into finer and finer grits, followed by by a plastic polishing compound such as Novis or one of the polishes used for auto paint.
Regards
Arran




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 6072 online users. [Complete List]
» 1 Member(s) | 6071 Guest(s)
Avatar

>