[Eric Adams]

Hi Guys,

I have an interesting problem that is driving me crazy. On this AM/FM radio I have replaced all caps, tested the resistors, tested the tubes and replaced 2. I aligned it, both AM and FM with a VTVM and everything checked ok. The problem is that AM works great, but FM will not pick up any stations. Only dead air anywhere on the dial. Is there anything that anyone can think of? Any help will be appreciated.

http://www.nostalgiaair.org/Resources/572/M0025572.htm
https://www.radiomuseum.org/r/zenith_h7 ... h02z2.html

Thanks,

[Radioroslyn]

So I'm a little lost. If you did the alignment for the FM section was it working then??

[Eric Adams]

Hi Terry,

That's what is driving me crazy. The alignment went just the way it was supposed to, but just dead air.

Thanks,

[Radioroslyn]

So you can pickup the FM signal from the generator @ 98mc?

[David]

   
The selector switch on those sets can be a pain. Try giving it a good cleaning.

[Eric Adams]

I checked it again. @ 98 it comes through all over the dial. Does that tell you anything?

[Eric Adams]

I cleaned the switch very thoroughly. No change. Thanks.

[Eric Adams]

Happy new year everyone. Sorry it took a while to get back to you, but after reading, searching the internet and pulling my hair out, I found the problem. It was a bad cap on the FM osc. coil. I replaced it with a cap from a junk chassis and all is fine.

Thanks to everyone who had some input.