Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale
State, Province, Country: PA
Just recapped.. turned on and at 100 Volts in draws 400 Ma..
B+ to ground is approx 310 Volts DC..
No audio.. When turning volume up and down get scratches.. No noticeable Hum..
Can scan schematic . Replaced the Bias cell with Watch battery.. Plus to Ground..
Skip
Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale
State, Province, Country: PA
OK Here are schematics..
[Image:
https://farm5.staticflickr.com/4843/4518...c178_b.jpg]
[Image:
https://farm5.staticflickr.com/4822/4518...af0e_b.jpg]
[Image:
https://farm5.staticflickr.com/4828/4518...ee59_b.jpg]
OK On second picture The Black and Yellow leads were reversed.. I put them to match the schematic so the Resistance of field coil would be right.. Did I goof???
Skip
(This post was last modified: 11-28-2018, 07:30 PM by
vecher.)
Posts: 16,533
Threads: 573
Joined: Oct 2011
City: Jackson
State, Province, Country: NJ
When touching 2nd det cap or the output tube's grid, is there hum?
Are there voltages on plates?
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale
State, Province, Country: PA
Ok Stupid mistake again.. I forgot to install a resistor.. No voltage to OSC.. After install worked correctly..
Next Question Where is the best spot to hook up my VTVM to measure the AVC Voltage? Cannot get yo speaker voice coil to put on my output meter..
Skip
(This post was last modified: 11-29-2018, 06:06 PM by
vecher.)
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
