Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 87 Help Needed
#1

Hi, I just got a Philco 87 at the local thrift store and I'm going to start and restore it. It looks to be all original minus a few parts.(still has most globe style tubes). It's missing the three smaller knobs (tuning knob is there). Can they be found? About half the dial is worn. Anyone knows if it can be restored? Also the decretive work in the speaker opening, was that on all modle 87's? I saw on a philco site one had a tapestry print. Is that also correct? Any and all help would be appreciated. thanks, Richard
------------------
Richard
#2

Hi Richard

Yes, knobs and reproduction dial scales are readily available; sources for these may be found on this site's Parts Sources page:
http://www.philcoradio.com/resource.htm

Earlier Model 87 lowboys have the decorative cutouts in the speaker grill, and plain gold cloth identical to that used in Model 20. Later 87 lowboys use the "tapestry" cloth, with no grille cutouts.

Reproduction cloth may be found at http://www.grillecloth.com .

--
Ron Ramirez
Ferdinand IN
#3

Thanks Ron, I ordered the speaker cover print and started looking for the other parts. This is the oldest one yet I have restored. Electronics pretty simple. Thanks again, Richard




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
I think the chassis is painted.morzh — 08:13 PM
Philco 38-2 Automatic Tuning
Honestrly, the original is quite acceptable and, it seems to me, can be cleaned.morzh — 08:11 PM
Philco 41-608 changer coupler
Mondial left a thread about remanufacturing thois type coupler.morzh — 08:09 PM
IF can wire size and Rubber mounts?
Are you talking about rewinding or rewiring? For rewiring, meaning runnin wires to the coil from other components, the ...morzh — 08:08 PM
12' Philco
I wonder who would be able to "no stoop" with this one.morzh — 08:05 PM
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Philco 41-608 changer coupler
I am working on a Philco 41-608 with the gear-driven changer.  The coupling (#35-2220) between the motor assembly and th...alangard — 06:29 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM

[-]
Who's Online
There are currently 2166 online users. [Complete List]
» 5 Member(s) | 2161 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>