Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What do I have here?
#1

Hello to all,
While out digging thru a few antique stores today, I ran across this little gem. It is a small bakelite with leatherette panels and a brass or gold colored grill over the speaker.  It is AC powered, no battery compartment.  AM broadcast band only. It opens up, as shown.  The chassis appears to be encased in a perforated metallic case within the bakelite shell. The loop antenna is attached to the back side.  The controls are two thumb wheels on the top, front area.  I have never seen anything like it. It does have the Philco name on the front.  The paper tag on the inside is almost completely destroyed from damage by cord storage.
Any ideas what I might have here? Model no. etc.?

Thanks for looking.    

   

Chris H
N9WHH
#2

https://philcoradio.com/gallery2/1949a/#Model_49-603
Standard ac/dc set w/an odd cabinet.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Thank you Terry. I looked around but couldn’t find anything that looked like it. It appears to be in pretty good shape and should clean up well. I figured it was an AC/DC chassis.

Thanks, again.

Chris H
N9WHH




Users browsing this thread:
[-]
Recent Posts
Need to purchase some accessories for restoration of my Old Philco Radio
Hi Paulo, Welcome to the Philco Phorum. I can see why you want to find good reproduction parts. That is a bea...MrFixr55 — 11:10 PM
HiFi (Chifi) tube amp build - but my own design.
Tim, I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM

[-]
Who's Online
There are currently 1937 online users. [Complete List]
» 3 Member(s) | 1934 Guest(s)
AvatarAvatarAvatar

>