Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 42-321 dial cord diagram
#1

I am not able to find the dial cord diagram for the Philco 42-321. I've checked Sams Dial stringer. Not there.
All help is welcomed
Thanks Again
ABV
#2

The 42-322 is the same set electrically as the 42-321 so perhaps the dial stringing is the same also.  There are some pics and a hand drawn dial string diagram in my notes. I no longer own the set. (This was the first set I worked on so took a lot of notes.)

http://home.ptd.net/~coraor/documents/Ph...ration.pdf
#3

Bob,
I did look for closer models you suggested. I was not able to find it directly.
What I did do was go back to Sams radio cord stringing pdf file and started to just look through many
cord diagrams that were close to this radio model PHILCO 42-321. The position of the tuner wheel, the knob and the guide wheels.
I found one that is close. ( drawing #343) I strung it out and it works.
This pdf file should be helpful for others.
Thank You for your response Icon_angel
ABV




Users browsing this thread:
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>