|
077 signal generator
02-07-2020, 07:28 PM
Im looking for someone who has a Philco 077 signal generator
that can help me with getting leads for the one I have. I do not
know what kind of plug that plugs into it. I would like to make a
set, any advice that can help would be appreciated.
02-07-2020, 09:11 PM
What size drill bit will fit into the connector?
When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
02-08-2020, 09:44 AM
Ok so what you are looking for are banana pin connectors. At 5/32 = a hair over 4mm. Something like this should work. https://www.ebay.com/itm/10x-BANANNA-4mm...9001!US!-1 If it seem too loose you can pry a little to increase the diameter. Just check the depth of your socket. Along w/these you'll need a piece a coax and a couple of alligator clips.
When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
« Next Oldest | Next Newest »
Users browsing this thread: |
|
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
