Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-280 shortwave
#1

I bought a 41-280 radio that had been restored. The AM works great but I can't pick anything up on short wave or police bands. Didn't expect to get anything on police bands but it would be nice to listen to shortwave. Anyone have any ideas?
#2

Make sure the buttons switches are ok, and the internal loop antenna connected correctly.
I know mine works on SW.
If all low ha ging fruits have been plucked and it still doesn't work, then you should start troubleshooting.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#3

Clean the band switch with De Ox It.
#4

What are you using for an antenna?

There are two factors here - an indoor antenna of a few feet of wire may not pick up much except a lot of interference. Second, depending on the design, the set might need the help of a good long-wire type aerial (at least, something set up outdoors) to get the best out of the higher frequency bands.

Good luck!

Ed

I don't hold with furniture that talks.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
Hi John, I don't have this radio, but I can supply some info: Based on your pic, pins 7,8 and 1 are used together...MrFixr55 — 02:02 PM
New Philco Repair Bench
As far as I know, the Repairbench does not work, and has not been working in a while. Chuck (we had that campaign looki...morzh — 01:33 PM
Radio city products 664 schematic request
Need a schematic or manual for the 664. The 663 may be similar.daveone23 — 12:38 PM
New Philco Repair Bench
Thanks Gary.dconant — 12:16 PM
New Philco Repair Bench
I tried accessing the site through our library and got the same response. It's reported to our tech gurus. GaryGarySP — 11:50 AM
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM

[-]
Who's Online
There are currently 4148 online users. [Complete List]
» 1 Member(s) | 4147 Guest(s)
Avatar

>