Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

schematic needed for 38-93b
#1

Further to my search for a circuit with a previous posting, I may have identified my radio after receiving my copy of Antique Radios by John Slusser. Would any one have a copy of the above model please ?

Regards
Rudy
#2

Rudy,
A note on this radio a radiomuseum.org says that you should use service info for 37-93:
http://www.radiomuseum.org/r/philco_38_93b_2.html
The schematic can be found here:
http://www.nostalgiaair.org/PagesByModel...013228.pdf

Carl
Northern Panhandle, WV
#3

Thanks for your reply Carl. Unfortunately the tube line up on Radio Museum did not line up with mine, also I couldn't get into Nostalgia Airs site for some reason. I shall keep trying.
Regards
Rudy
#4

Rudy,
What is the tube line up in yours?

Carl
Northern Panhandle, WV




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Delco car radio Peko vibrator converstion issues
Rich, There is an Australian website (Cool386.com) that has much useful info regarding repair and restoration of vibr...Joe Rossi — 07:29 PM
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM

[-]
Who's Online
There are currently 3667 online users. [Complete List]
» 4 Member(s) | 3663 Guest(s)
AvatarAvatarAvatarAvatar

>