Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Help identify my philco
#1

Hello,

Does anyone know what model this is or any other information?

Thank you in advance,
Sal

   
#2

Welcome to the Phorum! Could you possibly provide photos of the chassis? That would help identifying what model radio, anyway. I'm leaning toward it being a model 20 chassis based on what looks like the three operating knobs and the escuteon. Appears to have been cobbled into another makers cabinet, and not a bad job with the exception of the glaring red indicator bezel. Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#3

On first look the tuning knob is correct for a model 20, but the on/off and volume knobs are not. What are what look like black checkers on each side? The escuteon is a model 20, but would benefit with a brass screw instead of the sheet metal screw now attaching it. Others can jump in on the possible cabinet maker. Definite has the looks of a "Franken-Philco". Take care and BE HEALTHY! Gary

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
#4

Hi Sal,

Sorry to say that Gary is right. It's either a Philco model 20 or 21, in another manufacturers cabinet.
#5

The cabinet looks like it belonged to a FADA lowboy of 1930-31 vintage, regardless someone added an adapter plate to the front panel to accommodate the different knob locations of the replacement chassis.
Regards
Arran
#6

To spc091:

Please post a back view of the set so we may see what is inside. Thanks.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently no members online.

>