1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
H-691 Do I need batteries
Ralph
Junior Member
**
Posts: 30
Threads: 5
Joined: Nov 2021
City: Danvers State, Province, Country: MA
#1

04-05-2022, 06:24 PM
Im just getting into this H-691. Do I need to do anything special to run this without A and B type batteries. So far I changed a couple of resistors and electrolytics. I had to order 2000 ohm 10 watt resistor. Thanks Ralph
Find
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#2

04-05-2022, 07:55 PM
You should good to go. No batteries needed in the circuit when operating on ac. The 7.5vdc coming off of R-9 is critical. If too high it can shorten the life of the tubes filaments. Too low there won't be enough emission from the filament for the tube to operate at it's full potential. You would want to be somewhere between 7.0-7.8vdc.

GL
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
(This post was last modified: 04-05-2022, 07:58 PM by Radioroslyn.)
Find
Ralph
Junior Member
**
Posts: 30
Threads: 5
Joined: Nov 2021
City: Danvers State, Province, Country: MA
#3

04-06-2022, 07:09 AM
Thanks Terry, This is only my 3rd vintage radio for me to work on and wasn't sure about the batteries.Thanks, Ralph
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM
Philco Predicta Siesta picture over time getting dimmer
I found that the wire insulation was burnt.  The fly back needs corona dope! Why would someone put that there?Platinumblonde36 — 01:09 AM
Philco Predicta Siesta picture over time getting dimmer
This is what it looked like beforePlatinumblonde36 — 01:01 AM
Philco Predicta Siesta picture over time getting dimmer
Platinumblonde36 — 12:58 AM
Philco Predicta Siesta picture over time getting dimmer
Platinumblonde36 — 12:57 AM
Philco Predicta Siesta picture over time getting dimmer
I'm finding some strange things in my set and for the most part it's also original, so I need to start going over everyt...Platinumblonde36 — 12:55 AM
12' Philco
Not anymore Mike. Andre The Giant Born: May 19, 1946, Coulommiers, France Died: Jan 28, 1993 (46 years), Paris, Fran...RodB — 11:53 PM

[-]
Who's Online
There are currently 5046 online users. [Complete List]
» 2 Member(s) | 5044 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration