Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco IF Transformers
#1

Does anyone have a link or other documentation that lists the values of all the IF transformers used by Philco?  I'm trying to find other chassis' that used the same 2nd IF trans as was used in the model 52 since I'm having an issue with finding a junk mod 52 that i can strip.

Philco's 
86 Low Boy     71B      42-321T
90 High Boy    52B      46-1203
95 High Boy    118B     48-214     
112X Console     60B       48-206
118X Console     84B       49-506
41-608P Console   610B   76 High Boy
41-265 Console   37-89B   370LZ
52GC                38-35B
20 Baby Grand   38-10T
70 Baby Grand   41-221CI

#2

If that is a 52 baby grand with 175 IF, you might try a 262KC IF Meissner or Miller (plentiful ebay) as they have a broad range to get you up and running until you find 175.
#3

I don't recommend using a 260/262 kc IF transformer.

IF transformers from Philco models 111, 112, 90 (early and middle production), 51, and 52 all use 175 kc IF transformers. Model 17 does also; however, model 17 is less common.

Oh, and the documentation you asked for does not exist. I don't think anyone has compiled a list of all Philco IF transformers, their design frequencies, and the radios using them. However, the listing I gave you above covers all Philco home sets using a 175 kc IF.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4472 online users. [Complete List]
» 1 Member(s) | 4471 Guest(s)
Avatar

>