Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 45 cabinet
#1

I was wondering what finish to put on my philco 45 table radio , what mohawk stainfor the cabinet in most corners and what for the accent strips , that flowdown to the bottom of then radio on front ? there is nothing light colored left of the lighter colored accent strips i usually see on this model. it is dark walnut or has been stripped to that .
#2

The cabinet should be sprayed with Mohawk Extra Dark Walnut overall. The accent panels in front are Medium Walnut.

The grooves in front can be filled with tan nail polish - nail polish is lacquer-based, so it should not interact with the coats of clear lacquer when you apply these.

This picture shows what a 45C (and 28C) should look like:

http://www.philcoradio.com/gallery/1935a.htm#u

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM

[-]
Who's Online
There are currently 2864 online users. [Complete List]
» 3 Member(s) | 2861 Guest(s)
AvatarAvatarAvatar

>