1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Philco 89B Dial Cord Svchematic
Oscar Hernandez
Junior Member
**
Posts: 13
Threads: 7
Joined: Mar 2016
City: Laredo TX
#1

07-20-2023, 09:59 PM
Dear Friends
I'm looking for an schematic on the philco 89B dial cord.
I hope somebody could help me with this
Thanks in advance for your help
Oscar
Find
DaleHCook
Philco, Zenith, and Howard Phan
***
Posts: 161
Threads: 8
Joined: Apr 2023
City: Roanoke State, Province, Country: Virginia
#2

07-21-2023, 03:12 PM
It would not be on a schematic because that is an electronic diagram - stringing would be on a mechanical diagram. I have nearly finished indexing all of the Philco service information on this site and have not found a dial stringing diagram for that model, which is not unusual for a set of that vintage.
Dale H. Cook, GR/HP/Tek Collector, Roanoke/Lynchburg, VA
https://plymouthcolony.net/starcity/radios/
Website Find
MrFixr55
Phorum Expert
*****
Posts: 1,032
Threads: 9
Joined: Jul 2020
City: Greenlawn State, Province, Country: NY
#3

07-22-2023, 06:38 AM
Sorry Oscar,

I had an early model 89 on my bench for 3 years, but its owner finally picked it up. I do remember that the stringing is not that complex. Search the Phorum, I seem to remember that another member had provided a picture of the tuning cap assembly where the stringing is visible. If I find it, I will post again in this thread.

Good luck.
"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
Best Regards, 

MrFixr55
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4756 online users. [Complete List]
» 1 Member(s) | 4755 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration