Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-1226 Mystery Cap
#1

I'm working on a 46-1226 Am/Lw/Sw/Phono console. Has anyone else done this beastie? There is a rather large cap that I can not determine its value for replacement. I've consulted the Schematic in the Rider's on Nostalgia Air without much luck.

It's a very large yellow tubular cap with wax coating that's located about dead-center in the middle of the bottom of the chassis. The ends are attached to a large terminal strip and one end goes to one of the electrolytic caps and the other to one of terminals on the volume control pot.

I accidentally scratched off the value while trying to cut through the filthy wax. I thought it said something like 25 - but don't recall and there's nothing on the schematic that makes sense.

Can anyone help? I could take a photo of the cap in location if it would help.

Thanks,
James
#2

What C number is it on the riders underside picture?
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
#3

Do you have the schematic for this radio? The service information will tell you what capacitor it is. Philco service literature for their 1946 models are very detailed.

If you don't have it, you need to get hold of Chuck and buy it from him - you won't be disappointed.

http://www.philcorepairbench.com/schematics.htm

--
Ron Ramirez
Ferdinand IN




Users browsing this thread:
[-]
Recent Posts
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM

[-]
Who's Online
There are currently 3374 online users. [Complete List]
» 4 Member(s) | 3370 Guest(s)
AvatarAvatarAvatarAvatar

>