Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1948 Victrola 77U (with Phonograph)
#1

I just aquired the above unit, Recapped it and got her all cleaned up. Radio working great, turn table works and all mechanics are doing what they should. My problem is I am not getting any sound from the needle, and all wires are intact. Has anyone here had any experience with these units?

Jerry Gatewood
Philco 41-280 (121)
#2

As with any player with a crystal pickup, the cartridge will be dead. You'll need to find someone who can open the pickup case, and put a crystal element in place of the dead one. These elements are gotten from newer "donor" pickup cartridges.

I understand that it isn't vary hard; just tricky, but by doing that, you can have the set back in operation once again.
#3

Thanks Doug, I was afraid of that. I will just restore everything and leave that until I can find one. There are absolutely NO resources on the internet for this particular radio at all.

Jerry Gatewood
Philco 41-280 (121)
#4

There is a thread here on the Phorum which shows you how to rebuild your own crystal cartridge.

http://www.philcoradio.com/phorum/showth...p?tid=1019

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM

[-]
Who's Online
There are currently no members online.

>